Issue link: https://resources.rand3d.com/i/1175370
CATIA V5-6R2018: Introduction for Managers and Reviewers ii © 2019, ASCENT - Center for Technical Knowledge® Practice 2a Feature Management ....................................................... 2-10 Chapter 3: Part Information ......................................................................... 3-1 3.1 Measuring Items .............................................................................. 3-2 3.2 Updating Measurements ................................................................ 3-4 3.3 Measuring Between Items .............................................................. 3-5 Standard Mode Measure Between.................................................... 3-6 Chain Mode Measure Between ......................................................... 3-8 Fan Mode Measure Between ............................................................ 3-9 Measuring with Reference Elements ............................................. 3-10 3.4 Measuring Inertia .......................................................................... 3-11 Apply a Material .............................................................................. 3-11 Viewing the Material ........................................................................ 3-12 Measure Inertia 3D.......................................................................... 3-14 Measure Inertia 2D.......................................................................... 3-17 3.5 Dynamic Sectioning ...................................................................... 3-18 3.6 Feature Investigation .................................................................... 3-20 Scanning the Model ........................................................................ 3-20 Practice 3a Take Measurements ......................................................... 3-22 Practice 3b Measuring with Reference Geometry............................. 3-32 Chapter 4: Assembly Design ....................................................................... 4-1 4.1 Assembly Workbench..................................................................... 4-2 Commonly Used Toolbars................................................................. 4-2 4.2 Create an Assembly ........................................................................ 4-3 Product Properties ............................................................................ 4-3 Adding Components.......................................................................... 4-4 Product Structure .............................................................................. 4-5 4.3 Use the Compass ............................................................................ 4-7 Automatic Snap ................................................................................. 4-8 4.4 Constraints .................................................................................... 4-11 Assembly Considerations................................................................ 4-16 4.5 Product Data Management ........................................................... 4-17 What is PDM? ................................................................................. 4-17 PDM Considerations ....................................................................... 4-18 Practice 4a Creating Assemblies I...................................................... 4-19 Practice 4b Creating Assemblies II..................................................... 4-28 Practice 4c Creating Assemblies III.................................................... 4-38 Practice 4d (Optional) Motor Assembly ............................................. 4-41 Sample provided by ASCENT for review only All copying and reuse strictly forbidden.