Issue link: https://resources.rand3d.com/i/1516026
training@rand.com www.rand3d.com 877.726.3243 Creo Parametric 10.0 Training Sheet Metal Design Learning Guide Contents Chapter 1: Introduction to Sheet Metal Modeling • 1.1 Sheet Metal Environment • 1.2 Display of Sheet Metal Parts • 1.3 Parameters • 1.4 Orienting a Sheet Metal Part • 1.5 Developed Length of Sheet Metal Bends • 1.6 Designing in Sheetmetal Mode Chapter 2: Primary Walls • 2.1 Primary Walls • 2.2 Capturing Design Intent in Sketcher Chapter 3: Secondary Walls • 3.1 Selecting an Attachment Edge • 3.2 Flat Wall • 3.3 Flange Wall • 3.4 Twisted Wall • 3.5 Extended Wall • 3.6 Unattached Walls • 3.7 Wall Section Reuse • 3.8 Bend Relief Chapter 4: Regular Unbends, Bend Backs, & Extruded Cuts • 4.1 Unbending Sheet Metal Geometry • 4.2 Bending Back Unbent Geometry • 4.3 Solid and Sheet Metal Cuts • 4.4 Creating a Cut Requiring Unbend and Bend Back Features Chapter 5: Notches and Punches • 5.1 Corner Relief • 5.2 Introduction to Notches and Punches • 5.3 Creating Notch and Punch UDFs • 5.4 Placing Notch or Punch UDFs Chapter 6: Bend Features • 6.1 Bend Features • 6.2 Creating a Bend Feature • 6.3 Position of the Bend Line • 6.4 Bend Line Adjustment • 6.5 Bend Line Notes Chapter 7: Unbending Complex Geometry • 7.1 Ruled and Non-Ruled Geometry • 7.2 Unbending Non-Ruled Geometry • 7.3 Split Area Feature • 7.4 Cross Section Driven Unbends • 7.5 Rip Features Chapter 8: Sheet Metal Forms • 8.1 Introduction to Form Features • 8.2 Placing a Punch or Die Form Feature • 8.3 Flattening Form Geometry • 8.4 Flat Patterns • 8.5 Flattened Representation • 8.6 Unstamp Edges Feature • 8.7 Form Feature Restrictions Chapter 9: Documenting a Sheet Metal Part • 9.1 Flat States • 9.2 Creating Flat States • 9.3 Opening Flat State Instances • 9.4 Adding a Flat State Instance to a Drawing • 9.5 Documenting the Bend Order Chapter 10: Converting Solid Parts • 10.1 Converting Solid Parts • 10.2 Conversion Feature • 10.3 Additional Conversion Options Chapter 11: Sheet Metal Setup • 11.1 Calculating the Developed Length • 11.2 Y-Factor and the Default Formula • 11.3 Bend Tables • 11.4 Sheet Metal Parameters and Relations • 11.5 Default Fixed Geometry Chapter 12: Investigating a Sheet Metal Part • 12.1 Investigation Tools • 12.2 Sheet Metal Reports • 12.3 Design Rules