Assembly Operations
© 2019, ASCENT - Center for Technical Knowledge® 1–11
To change the type of existing constraint, click (Change
Constraint) and select the new constraint type in the Possible
Constraints dialog box, as shown in Figure 1–8.
Figure 1–8
Constraint
Creation
Three different constraint creation modes can be activated. The
system stays in the selected mode until a different mode has
been selected. The Constraint Creation toolbar is shown in
Figure 1–9.
Figure 1–9
The three constraint creation modes are described as follows:
Mode
Description
Default mode: Selects references selected between two
components.
Chain mode: Selects references from multiple components to
be incrementally offset.
Stack mode: Selects a common reference for multiple
components.
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
