Overview
© 2019, ASCENT - Center for Technical Knowledge® 1–9
Toolbars and Menus
The primary way of interacting with the software is to select icons
in the toolbars or commands in the menu bar. You can customize
the interface by arranging the location of the toolbars and
selecting the icons to display.
Message Area
In many cases, the software displays a single line prompt in the
Message area, intended to help you perform a certain task. The
following are the four messages that correspond to creating the
keyhole sketch shown in Figure 1–10.
1. Define the center of the large radius.
2. Define the center of the small radius.
3. Select a point on the key hole profile to define the small
radius.
4. Select a point on the key hole profile to define the large
radius.
Figure 1–10
Select #1
Select #2
Select #3
Select #4
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
