CATIA V5-6R2018: Introduction to Modeling
1–16 © 2019, ASCENT - Center for Technical Knowledge®
An alternative method is as follows:
1. Position the cursor over the geometry that you want to select.
2. Press and hold and then select the model. The
software lists all of the entities that are beneath the selection
point.
3. Right-click to navigate through the possible selections, or
move the cursor to make the appropriate selection, as shown
in Figure 1–18.
Figure 1–18
This option is controlled through the Preselect in geometry
view option (Tools>Options>General>Display>Navigation
tab).
User-Defined Views
To create a user-defined view, orient the model to the required
orientation and select View>Named Views. The Named Views
dialog box opens, as shown in Figure 1–19.
Figure 1–19
• Click Add. The name defaults to Camera 1. Enter the
required name and click Apply.
Select any of
the entities
from the list
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
