Introduction to Surfacing
© 2019, ASCENT - Center for Technical Knowledge® 1–13
If the mass properties of your model are required or you intend
on performing additional solid modeling, you must create solid
geometry from the surfaces. You must take the model back to
the Part Design workbench and use the Surface-Based Features
toolbar options to create solid geometry. These options include
features, such as Close Surface (which fills a surface model
with solid geometry) or Thick Surface (which adds solid material
to either side of a surface). The solid geometry is added to the
PartBody, as shown in Figure 1–11.
Figure 1–11
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
