3DEXPERIENCE 2022x: Introduction for Managers and Reviewers
1–32 © 2022, ASCENT - Center for Technical Knowledge®
2. In the Edge Fillet Definition dialog box, change Radius to
6.00 mm (0.236 in), as shown in Figure 1–40. Click OK.
Figure 1–40
3. In the specification tree, double-click on Hole.1.
4. In the Hole Definition dialog box, change the Diameter to
13.00 mm (0.512 in), and click OK. The updated model is
shown in Figure 1–41.
Figure 1–41
Change this value
to 6.00
Change this
hole
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
