Introduction to 3D T&A
© 2022, ASCENT - Center for Technical Knowledge® 1–15
New models are created using the default standard. To change
the standard for existing annotation sets, right-click on the
Annotation Set.1 branch of the specification tree and select
Properties. Use the drop-down list in the Standards tab of the
Properties dialog box to change the standard for a model, as
shown in Figure 1–8.
Figure 1–8
Before creating any annotations, define an annotation or view
plane by referencing any planar face or reference plane in the
model. The view plane provides an orientation reference for the
annotation. When creating new annotations, they are associated
with the active view plane. This enables annotations to be
selected based on the view plane that was active during their
creation.
The top face of the part shown in Figure 1–9 has been defined
as an annotation plane.
Figure 1–9
Step 2 - Define the annotation planes.
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
