Sample Chapters - CATIA

3DEXPERIENCE CATIA 2022x: Advanced Part Design

Issue link: https://resources.rand3d.com/i/1500974

Contents of this Issue

Navigation

Page 19 of 35

3DEXPERIENCE CATIA 2022x: Advanced Part Design 1–8 © 2023, ASCENT - Center for Technical Knowledge® Design Considerations Consider the following design requirements, as shown in Figure 1–3. Note that relations (formulas) cannot be used. Figure 1–3 Before you begin modeling, ask the following questions: • What is the best selection for a Base feature? • What is the second feature going to be? • What is the complete feature order going to be? • Which references are going to be used in Sketcher? • How are you going to incorporate the design requirements shown in Figure 1–4? • Which depth options should be used? The surface of the flange and the end of this pipe segment must remain co-planar. The outside diameter of both flanges is the same. The pipe segment and flange outside diameters must automatically update if the inside diameter of the pipe is changed. Pipe segment Flange Flange Sample provided by ASCENT for review only All copying and reuse strictly forbidden.

Articles in this issue

view archives of Sample Chapters - CATIA - 3DEXPERIENCE CATIA 2022x: Advanced Part Design