3DEXPERIENCE CATIA 2022x: Advanced Part Design
1–14 © 2023, ASCENT - Center for Technical Knowledge®
Task 3 - Analyze the sketch.
1. Edit Sketch.2 and click (Sketch Solving Status). The
sketch status indicates that the sketch is fully constrained, as
shown in Figure 1–11.
Figure 1–11
2. Click (Sketch Analysis).
3. In the Sketch Analysis dialog box, select the Geometry tab.
4. Press and hold and select the following:
• Projection.9/Mark.1 and Projection.13/Mark.1.
• The three Implicit Profiles at the end of the list.
5. In the Corrective Actions area, click (Set in Construction
Mode) to set the appropriate sketch geometry in Construction
mode, as shown in Figure 1–12.
Figure 1–12
Ensure that the Geometry tab is active
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
