CATIA V5-6R2018: Introduction to Modeling
1–24 © 2019, ASCENT - Center for Technical Knowledge®
If you accidentally
change the focus to the
specification tree, you
must understand how to
activate the model.
3. Select the coordinate system in the lower right corner of the
screen, as shown in Figure 1–30. The model turns gray,
indicating that it is inactive. Select it again to make it active.
Figure 1–30
You can also change the focus to the specification tree by
selecting any of the tree branches.
4. Press several times to hide and display the
specification tree.
Task 7 - Change the size of several features.
1. Place the cursor over the large fillet at the base of the neck to
highlight it, as shown in Figure 1–31. Double-click on it to
display the radius dimension.
Figure 1–31
2. In the Edge Fillet Definition dialog box, change Radius to
6.00 mm (0.236 in), as shown in Figure 1–32. Click OK.
Figure 1–32
Change this fillet
Change this
value to 6.00
Sample
provided
by
ASCENT
for
review
only
All
copying
and
reuse
strictly
forbidden.
